PU design 121506

Overunity Heating Unit By Euler Cheung Revised 12/15/06

Switch

Power

Green denote electromagnetic core. Blue denote metallic core, could be any ferromagnetic material. Operating Cycle: 1. The switch cause electrical current to flow ONLY in the left group of coils. Thus the coil group in the left begin to magnetize. And the right group of coil begin to demagnetize. 2. Thus the metallic core is attached to the coil group in the left, The Magnetic flux is flowing in anti-clockwise direction through the metal in the middle. 3. At the same time the left coil group move into the coils, the cores of the right coil group is being pulled out from the coils. 4. The switch cause electrical current to flow ONLY in the right group of coils. Thus the coil group in the right begin to magnetize. And the left

group of coil begin to demagnetize. 5. Thus the metallic core is attached to the coil group in the right. The Magnetic flux is flowing in anti-clockwise direction through the metal in the middle. Magnetic flux is flowing in clockwise direction through the metal in the middle. 6. At the same time the right coil group move into the coils, the cores of the left coil group is being pulled out from the coils. 7. Since there is a change of direction of Magnetic flux, the metal heat up. We could use this thermal energy to heat things up. The change of Magnetic flux is further increase by Parametric Power Conversion. Advantage: 1. Energy saving: Although it take 6 unit of electrical power to operate, it produce a total of 18 unit of thermal energy. (That is limit by the maximum Magnetizability of the metal core in the middle. And for Metal has higher level of Magnetic saturation point, we can use 8 unit to produce 32 unit; 10 unit to produce 50 unit... etc.) 2. Precise since the reaction time is short for all components, and control using electronic parts. Technicalities: 1. The construction of the middle metal: Direct heating with heated object in the middle, or indirect heating via the object placed on the top? 2. The waste heat. 3. The heating up of coil(could resolve by increase the frequency of switching). 4. The reaction time of metal core.